Alfa Transaxle forum
Area Servizio => Motor i Getriba => Autor teme: kobrakai - Sri 18:13:13 28.11.2012.
-
Do u have is a drawing rework engine mountings
4 cilindri ----> 6 cilindri
-
ask ljube-kugla :super:
-
when it comes to engine mounts, I used a panel of 75 td, the td are too high so I took advantage of the lower and middle plate and the rubber is too soft
after hanging the same as the V6 and the middle plate between the tire is punctured and M10 screw threaded and welded to the back, in which the aluminum bracket screws, and one has a small thorn that serves to mount does not rotate as the nut tightens
boom height should not be greater than 45mm and hardness of a tire must be at least 70 sora (as marked rubber hardness)
-
hmm
how about this?
[privitak je izbrisao admin]
-
did you check if there is enough clearence for the exhaust manifolds? the mount looks very wide.
-
No, did not check. this picture from Facebook. I wanted to know your opinion. :nod: